|
Over the past couple
of weeks, several of our routing users have been calling support
asking about the correct creation of electrical routing components
for their routing library. There is more to the creation of
these components than just dropping a solid model into a folder
like in other areas of the software. There are several steps
that need to be taken during the creation of these components
that will give SolidWorks additional information that it needs
to complete the route successfully. This video was created
to go through the basic steps that need to be taken for adding
components to the electrical routing library. It does not
however cover advanced topics like automating the assignment
of terminals at the drawing level. There are a couple
of steps that are crucial to the successful creation of working
routing components.
This video will
cover the addition of named mate references, adding components
to the xml library file, and the creation of the two dimensional
sketch block for the harness drawing.
Watch
Video Here
|
