Nodal versus Elemental Stresses

EmailFacebookGoogle+LinkedInTwitterShare

A common question that comes up in my training classes is : What should be examined – Nodal Stresses or Elemental Stresses?

When running a COSMOS analysis, the solver internally evaluates the stresses for each element in the model at specific locations inside the element (also called as Gaussian or Quadrature points). These points form the basis of numerical integration schemes used in Finite Element codes.

gaussian

The number of points selected is determined by the type and quality of the element. The subsequent stresses obtained at the Gaussian points inside each element are extrapolated to the nodes of the element.

Now, let us consider multiple elements sharing a node. In such a case, what would be the stresses at the node, if the gaussian point inside each element contributes a stress value to that node?

Nodal Values are the averaged values of stresses at each node. The value shown at the node is the average of the stresses from the gaussian points of each element that it belongs to. In the adjoining figure, the central node would carry a stress that is an average of the 6 stresses coming from the 6 elements that it belongs to.

nodal data

nodesvalues

The alternative method of displaying stresses is called Elemental Values. In this method, each element individually looks at the stresses at its nodes from the Gaussian points. The stress at the element is the average of the stresses seen at its corresponding nodes.

elementvalues

What stresses should one examine when taking a look at the stress plot?

Since the approach to average stresses is different for the two methods, the maximum stresses in the stress plot will be different. In the above two examples, the maximum values from nodal and elemental stresses are 5 and 5.66 respectively.

The degree of difference in the values is a reflection of the coarseness of the mesh, and hence the convergence of stress results. If the values are very different, it is a reflection of the mesh being too coarse at the high stress location. Hence, the mesh needs to be refined at those locations using Local Mesh Control.

Comparing nodal stresses and elemental stresses is a way of understanding if the mesh is fine enough, and if the results have converged at the highest stress location in the geometry.