Installing New Hinges on the Stratasys Objet 30 Series

EmailFacebookLinkedInTwitterShare

Over time the hinges on a Stratasys Objet 30 Polyjet 3D Printer can become loose which may make the printer’s lid unable stay open. In order to fix this new hinges can be installed. This can be done as a service visit, but can also be easily done by the customer. Here are the steps for hinge replacement.  Required tools: 3 mm Allen Wrench Flat Head Screwdriver Instructions: There are 8 screws that hold the back panel in place. Depending […]

Read More

What to do When Material is Stuck in Head of a Stratasys Dimension 1200 ES

EmailFacebookLinkedInTwitterShare

Occasionally model or support filament can get stuck in an FDM(Fused Deposition Modeling) 3D printer head because the tip of the material strand expanded and is too large for it to back out of the head. Below is a guide to removing that filament from a Stratasys Dimension 3D printer. First, use the LCD display to put the machine into “Head Maintenance” mode. From “Idle”, press “Maintenance” then press, “Machine.” If the printer is not fully warmed up it may […]

Read More