Stratasys 3D Printing: Manual / Alternative Load Cell Calibration

EmailFacebookLinkedInTwitterShare

Manual / Alternative Load Cell Calibration   In some cases, the Stratasys Polyjet desktop models will require a manual load cell calibration.  In the case where the load cell calibration wizard does not correctly, calibrate the weight using this method:   First off, remove all bottles and waste containers from the material bay.   In the printer application, select Maintenance > Calibration.     Select the Weight Sensor tab.  From the Cartridge list, select the weight sensor you want to […]

Read More

Waste Material leaking – Stratasys 3D Printer Support Tip

EmailFacebookLinkedInTwitterShare

In the event there is waste material leaking – First, check the waste container and make sure the cap isn’t over tightened. If the cap is over tightened it will twist the bag inside the box and reduce volume and cause an overflow.  When putting the cap on the threads should just barely catch.  It should just be tight enough to hold the cap on.  If it still leaks perform a load cell calibration. This will calibrate the scales under […]

Read More