My Stratasys Desktop 3D Printer is in Emulation Mode(What do I do?) – Stratasys 3D Printer Support Tip

EmailFacebookLinkedInTwitterShare

In the event that your 3D printer goes into Emulation Mode, there are some things you can do to fix it yourself.  The printer may go into emulation mode when/if the config files become corrupt or the Hard Drive is starting to fail.  This procedure may not resolve the issue if the Hard Drive is going bad.  So, what we are going to do is find a copy of known good config files and replace them on the printer.  They […]

Read More

Resume Print Jobs – Stratasys 3D Printer Support Tip

EmailFacebookLinkedInTwitterShare

In the event that your 3D Printer stops printing in the middle of a print job, it can resume where it left off.  To do this, go to job manager and select the current print job.  Then select resume from the icons above.  A box will open stating to enter the slice to resume from.  There may already be a number in this box.  You will have to go to the Objet interface on the printer computer to get the […]

Read More

Proper 3D Printer Shutdown – Stratasys 3D Printer Support Tip

EmailFacebookLinkedInTwitterShare

It is very important to shut a Stratasys machine down properly when not in use.  This will prevent material from getting clogged in the tubing and print heads.  The printheads may become permanently damaged if the proper precedures are not performed.  If your 3D Printer is not going to be in use for two to three weeks, run the shutdown wizard.  If your 3D Printer will not be in use for more than three weeks,  run the Machine flush/fill wizard […]

Read More